Oldcastle-buildingenvelope 3000 Series Thermal MultiPlane User Manual download pdf (Page 30)

DETAIL "A"

DETAIL "B"

15°

SEAL CORNERS AT

GLAZING TRACK PRIOR

TO SETTING GLASS.

MITER HORIZONTAL GASKET TO VERTICAL GASKET

INSIDE GLAZED SYSTEMS

GLAZING GUIDELINES

SEAL CORNERS GASKET

RACE AT WATER

DIVERTER.

1) REMOVE GASKETS FROM ROLL AND ALLOW TO RELAX OVERNIGHT.

ALL GASKETS TO BE CUT D.L.O. + 1/4" PER FOOT.

2) VERTICAL GASKETS RUN THRU HORIZONTAL GASKETS.

HORIZONTAL GASKETS SHOULD BE MITERED ON ENDS AS SHOWN IN DETAIL “A”.

3) INSTALL EXTERIOR GASKETS PRIOR TO GLAZING. CORNERS OF EXTERIOR GASKETS TO BE SET IN

SEALANT (DTL."B") AND CORNERS SEALED JUST PRIOR TO SETTING GLASS (DTL."A").

NOTE: CLEAN GASKETS AND SURFACES WITH ISOPOPYL ALCOHOL PRIOR TO

SEALING CORNERS.

4) LOCATE SETTING BLOCKS AT EITHER 1/4 POINTS OR 1/8 POINTS, DEPENDENT ON SIZE OF GLASS.

6) GLAZE OPENINGS FROM BOTTOM TO TOP. INSTALL WATER DIVERTERS IN HORIZONTAL ABOVE,

AFTER LITE BELOW IS IN POSITION

7) WATER DIVERTERS MUST BE LOCATED ON EACH END OF HORIZONTALS

AND SET IN SEALANT.

8) WHEN INSTALLING GLASS: FIRST, WET TOP OF SETTING BLOCK WITH SOAPY WATER.

ONCE GLASS IS SET IN PLACE, PUSH GLASS AGAINST GASKET AT SETTING BLOCK AREA.

FAILURE TO DO SO MAY CAUSE DIAGONAL CRACKS TOWARDS SETTING BLOCKS DUE TO

GLASS BENDING WHILE INSTALLING GASKET(S) IN CORNERS.







S E R I E S 3 0 0 0 T H E R M A L M U L T I P L A N E I N S T A L L A T I O N M A N U A L

5) GLASS BITE AT TYPICAL HORIZONTAL & VERTICAL MEMBERS IS 7/16”. AT SSG VERTICAL 3/4”.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 54 55

No comments

Oldcastle-buildingenvelope 3000 Series Thermal MultiPlane User Manual Page 30